ALLPAC 480| PRESSURE: | TO 725 psi | | TEMPERATURE: | TO 430 F | | SPEED: | TO 9800 fpm | | STD SIZES: | 3/4" TO 11-3/4" |
|
Single, balanced multi-spring seal with springs outside the product to avoid clogging. Faces are made from silicon carbide. Clean component design and large clearances between seal and shaft sleeve, robust construction. |
| SL-5000 |
Singe balanced multi-spring cartridge pusher seal specifically designed for abrasive slurry services. Unique design exposes seal faces to pumped product for maximum heat dissipation - eliminates a common failure point. Special shroud protects compression springs in stationary portion of seal, and rotor drive pin, from weepage build-up. Pre-set cartridge design and centering tabs simplify installation. |
SLC| STD SIZES: | 1-1/4" TO 7-1/8" |
|
Single balanced conical washer spring cartridge seal, designed to operate without a flush in tough slurries. No flush increases plant efficiency, reduces operating costs and eliminates product contamination. The seal incorporates a unique non-clogging cone spring design that increases seal reliability. |
SLM-6100| STD SIZES: | 1-1/4" TO 8-1/2" |
|
Singe balanced multi-spring cartridge pusher seal in flexible stator design with quench containment device. Rugged primary seal faces of sintered silicon carbide in a monoblock configuration. Available with quench containment device as an outboard seal that can be run with low pressure water closed loop barrier system or as a single seal the Syn-Lube system that requires no other equipment. |
SLM-6200| STD SIZES: | 1-1/4" TO 8-1/2" |
|
Double balanced cartridge multi-spring pusher seal used in very abrasive applications where corrosive, toxic or volatile liquids are being handled and a single seal is not acceptable. The inner and outer seal faces are interchangeable. The outer seal is shrouded by gland as added safety feature. No bypass or external flush needed. The seal tolerates pressure reversals. Requires enlarged stuffing box. Based on the SLM-6000. |
